SOFTWARE / INFRASTRUCTURE / SECURITY / KENYA
Done
Action completed
Case Study Wireless Networking & ISP Solutions Point-to-Point Wireless Links Intermediate • 6 min read

Aligning outdoor wireless radios

P Author: Peter Mwangi (Senior Network & Field Infrastructure Engineer)
Reviewed by: Lawrence Kamau (Lead Systems Architect & Infrastructure Engineer)
Published: May 1, 2026 • Last Updated: Nov 22, 2026 • Target Hardware: Directional dish and panel radios including Cambium Force 300-25/19 and Ubiquiti PowerBeam / NanoStation.

Purpose: Perform precision horizontal (azimuth) and vertical (elevation) antenna alignment so the radio locks onto the main antenna lobe rather than weaker side lobes.

Prerequisites

  • Pre-calculated compass bearing and elevation angle between Site A and Site B.
  • Audio alignment tone enabled or live eAlign / airOS alignment monitor open on a technician phone/laptop.
  • Proper safety harness, grounded mast, and weatherproof tape/mastic.

Step-by-Step Configuration

STEP 01 — Set Initial Compass Azimuth & Level Mast

Confirm the mounting pole is plumb vertical using a spirit level, then point the dish toward the target compass bearing.

STEP 02 — Sweep Horizontal Azimuth Slowly

Loosen azimuth bolts slightly and sweep slowly left-to-right across a 20° arc, pausing 2 seconds per degree to account for RSSI polling delay, noting the peak signal.

STEP 03 — Avoid Side-Lobe False Peaks

High-gain dishes (25 dBi+) have side lobes 10–15 dB weaker than the main beam. Sweep past the first peak to verify you have found the true strongest center lobe.

STEP 04 — Sweep Vertical Elevation & Torque Bolts

Lock azimuth at peak RSSI, then sweep vertical tilt up and down to peak both H and V chains equally. Tighten hardware evenly without shifting aim.

STEP 05 — Weatherproof Connectors & Drip Loop

Form a cable drip loop below the radio port and seal exposed glands with self-amalgamating rubber tape and UV-resistant PVC tape.

Expected Results & Verification

Achieves within 1–2 dB of theoretical free-space path loss RSSI with balanced H/V chains.

Troubleshooting Matrix

Issue:
Fix:
SECURITY HARDENING

Ensure outdoor shielded Cat6 drain wire is bonded to earth ground via an Ethernet surge protector at mast base and building entry.

BACKUP & RECOVERY

Photograph the aligned dish mount and save a screenshot of the post-alignment signal screen in the client site file.

P
Peter Mwangi Delight Engineering Team
Senior Network & Field Infrastructure Engineer
Specialization: Cambium ePMP, Ubiquiti airMAX, Fiber GPON / SFP+ Distribution & Tower Rigging

Leads physical wireless and optical deployments across Dagoretti South and greater Nairobi, specializing in interference mitigation and high-throughput point-to-point links.

Tested on Delight Living ISP Network (YouBroadband)
Nairobi NOC • Kabiria Road, Dagoretti South
Related Technical Guides
Was this engineering guide helpful?
Need professional installation, auditing, or troubleshooting? Request Network Consultation →