SOFTWARE / INFRASTRUCTURE / SECURITY / KENYA
Done
Action completed
Incident Report Wireless Networking & ISP Solutions Point-to-Multipoint Networks Intermediate • 7 min read

Configuring a point-to-multipoint wireless network

D Author: David Ochieng (ISP Field Operations & NOC Lead)
Reviewed by: Mercy Wanjiku (Full-Stack Software & Systems Engineer)
Published: May 1, 2026 • Last Updated: Nov 22, 2026 • Target Hardware: Cambium ePMP 3000 / 3000L / ePMP 2000 Sector Access Points with Force 300 Subscriber Modules.

Purpose: Scale a single base-station sector to serve multiple subscriber locations reliably using GPS TDD synchronization and frequency reuse.

Reference Network Topology
Point-to-Multipoint (PtMP) Tower Distribution with Management & Customer VLAN Separation
NODE 01
POP Core Router & Backhaul
MikroTik CCR/RB router fed via licensed/5GHz PtP backhaul
NODE 02
Tower Managed Switch
PoE switch isolating VLAN 99 (Radio Mgmt) from VLAN 120 (Subscriber Traffic)
NODE 03
Sector / Horn Access Point
Cambium ePMP AP or Ubiquiti Rocket Prism 5AC (GPS Sync / TDD)
NODE 04
Multiple Subscriber Modules (SMs)
Cambium Force 300 / Ubiquiti NanoStation & PowerBeam CPEs
NODE 05
Customer Premise Routers
Authenticated via PPPoE / DHCP Option 82 with per-plan rate limits

Prerequisites

  • Base station sector antenna mounted with clear line of sight over the target coverage arc (90° or 120°).
  • GPS sync puck connected and locked (3D Fix) when deploying multiple co-located sectors on a tower.

Step-by-Step Configuration

STEP 01 — Enable TDD & GPS Synchronization

Under Configuration -> Radio, set Synchronization Source to GPS on co-located sector APs and use matching Downlink/Uplink ratios (e.g., 75/25) and frame sizes (5 ms) across the tower.

STEP 02 — Implement ABAB Frequency Reuse

Assign alternating non-overlapping channels to back-to-back sectors on the same mast so opposing sectors reuse spectrum without self-interference.

STEP 03 — Configure Subscriber QoS & MIR Profiles

Define Maximum Information Rate (MIR) profiles or delegate rate-limiting cleanly to your MikroTik PPPoE/RADIUS core router.

STEP 04 — Enforce Subscriber Isolation

Enable Subscriber Module Isolation on the AP so customer premises cannot communicate directly with one another at Layer 2.

Expected Results & Verification

Multiple Subscriber Modules associate cleanly to the sector with deterministic TDD frame timing and zero peer-to-peer Layer-2 leakage.

Troubleshooting Matrix

Issue:
Fix:
SECURITY HARDENING

Always enable SM Isolation and DHCP Option 82 / PPPoE-only forwarding on subscriber ports.

BACKUP & RECOVERY

Document sector azimuths, elevation downtilt, channel assignments, and export AP config backups after every sector addition.

D
David Ochieng Delight Engineering Team
ISP Field Operations & NOC Lead
Specialization: Customer Premise Equipment (CPE), SLA Monitoring, VLAN Provisioning & Client Support

Manages daily NOC telemetry, subscriber ticket queues, and on-site client turn-ups across corporate and residential estates in Nairobi.

Tested on Delight Living ISP Network (YouBroadband)
Nairobi NOC • Kabiria Road, Dagoretti South
Related Technical Guides
Was this engineering guide helpful?
Need professional installation, auditing, or troubleshooting? Request Network Consultation →