SOFTWARE / INFRASTRUCTURE / SECURITY / KENYA
Done
Action completed
Lessons Learned Wireless Networking & ISP Solutions Wireless Network Planning Beginner • 5 min read

Understanding wireless signal strength and SNR

L Author: Lawrence Kamau (Lead Systems Architect & Infrastructure Engineer)
Reviewed by: Peter Mwangi (Senior Network & Field Infrastructure Engineer)
Published: May 1, 2026 • Last Updated: Nov 22, 2026 • Target Hardware: Cambium ePMP Force 300, Ubiquiti airMAX AC, and all 5 GHz outdoor broadband radios.

Purpose: Interpret RSSI (Received Signal Strength Indicator), Noise Floor, SNR (Signal-to-Noise Ratio), and Chain Balance to validate link health and modulation capacity.

Prerequisites

  • Access to the radio Wireless Monitor / Dashboard telemetry screen.

Step-by-Step Configuration

STEP 01 — Evaluate RSSI (Target: -48 dBm to -62 dBm)

RSSI measures received RF signal power in dBm (closer to 0 is stronger). Aim for -50 dBm to -60 dBm for stable 256-QAM throughput.

STEP 02 — Calculate Signal-to-Noise Ratio (SNR)

SNR is the margin between your signal and the local noise floor (e.g., -56 dBm signal minus -92 dBm noise = 36 dB SNR). Higher modulation (256-QAM) typically requires 30+ dB SNR.

STEP 03 — Verify Horizontal/Vertical Chain Balance

Dual-polarity MIMO radios report Chain 0 (H) and Chain 1 (V) separately. Both chains should read within 1–3 dB of each other.

CLI / Configuration Snippet

Signal Quality Reference (5 GHz 20/40 MHz):
-48 to -58 dBm  | SNR >= 32 dB  -> Optimal (256-QAM / MCS8-9)
-59 to -66 dBm  | SNR 25-31 dB  -> Good (64-QAM / MCS6-7)
-67 to -74 dBm  | SNR 18-24 dB  -> Marginal (16-QAM / Check alignment or Fresnel)
Below -75 dBm   | SNR < 18 dB   -> Unstable (Re-engineer antenna gain or height)
Expected Results & Verification

Engineers can diagnose whether low throughput is caused by weak signal (alignment/distance) or high noise floor (channel interference).

Troubleshooting Matrix

Issue:
Fix:
SECURITY HARDENING

Use spectrum analysis tools during site surveys rather than relying solely on passive SSID scans, which miss non-Wi-Fi interference.

BACKUP & RECOVERY

Record baseline RSSI, Noise Floor, and SNR values in your installation handover sheet for future degradation comparison.

L
Lawrence Kamau Delight Engineering Team
Lead Systems Architect & Infrastructure Engineer
Specialization: MikroTik RouterOS 7, FreeRADIUS, Linux CWP Hosting Clusters & Network Architecture

Directs network architecture and server infrastructure at Delight Office Solutions, overseeing the core YouBroadband ISP routing matrix and enterprise deployments.

Tested on Delight Living ISP Network (YouBroadband)
Nairobi NOC • Kabiria Road, Dagoretti South
Related Technical Guides
Was this engineering guide helpful?
Need professional installation, auditing, or troubleshooting? Request Network Consultation →