Configuring WAN and LAN
Purpose: Separate the upstream ISP WAN interface from a bridged internal LAN so internal ports switch cleanly at wire speed.
Prerequisites
- ISP WAN details (DHCP, Static IP, or PPPoE credentials) and chosen internal LAN subnet (e.g., 192.168.88.0/24).
Step-by-Step Configuration
In WinBox -> Bridge, add a bridge named bridge-lan and add internal Ethernet ports (ether2–ether5) under Bridge -> Ports.
Under IP -> Addresses, add 192.168.88.1/24 assigned to interface bridge-lan.
Add a static WAN IP under IP -> Addresses (plus default route under IP -> Routes) or enable IP -> DHCP Client on ether1.
Under IP -> DNS, set upstream servers (e.g., 1.1.1.1, 8.8.8.8) and enable Allow Remote Requests (protected by WAN drop firewall rules).
CLI / Configuration Snippet
# RouterOS v7.x — Bridge LAN & Static WAN Setup # Create LAN bridge and add ports /interface bridge add name=bridge-lan /interface bridge port add bridge=bridge-lan interface=ether2 /interface bridge port add bridge=bridge-lan interface=ether3 # Assign LAN IP & WAN IP /ip address add address=192.168.88.1/24 interface=bridge-lan /ip address add address=102.210.x.2/30 interface=ether1 /ip route add dst-address=0.0.0.0/0 gateway=102.210.x.1 /ip dns set servers=1.1.1.1,8.8.8.8 allow-remote-requests=yes
Router pings external internet hosts from New Terminal and serves as the default gateway for internal LAN devices.
Troubleshooting Matrix
Ensure Allow Remote Requests on DNS is paired with a firewall rule dropping UDP/TCP port 53 on the WAN interface to prevent DNS amplification abuse.
Export updated configuration to a dated .rsc file once WAN connectivity is confirmed.
Architects Delight internal platforms, including the YouBroadband billing engine, landlord revenue-sharing portal, and custom CRM ticketing solutions.