Monitoring network traffic
Purpose: Inspect real-time interface throughput, active PPPoE/VLAN utilization, and top bandwidth consumers using built-in RouterOS tools and SNMP.
Prerequisites
- Read or full WinBox/SSH access to the MikroTik router.
Step-by-Step Configuration
Open Interfaces in WinBox to monitor real-time Tx/Rx bitrates (bps) and packet rates (p/s) across WAN uplinks, bridges, and active <pppoe-*> bindings.
Open Tools -> Torch, select the WAN or customer interface, check Src. Address / Dst. Address / Protocol, and click Start to identify top talkers immediately.
Under IP -> SNMP, enable SNMP and restrict queries to your central monitoring server (LibreNMS/Zabbix/PRTG) for historical interface and CPU graphing.
CLI / Configuration Snippet
# RouterOS v7.x — Enable Restricted Read-Only SNMP for NOC Server /snmp community set [find default=yes] addresses=10.10.99.50/32 read-access=yes write-access=no /snmp set enabled=yes contact="[email protected]" location="Nairobi POP-01"
Engineers can pinpoint bandwidth spikes in seconds with Torch and retain historical utilization graphs on the central monitoring server.
Troubleshooting Matrix
Do not leave WinBox Graphing web pages exposed publicly on the WAN IP; restrict HTTP/Graphing access to Management IPs.
Configure remote Syslog forwarding (System -> Logging) so critical interface up/down and login events persist off-router.
Architects Delight internal platforms, including the YouBroadband billing engine, landlord revenue-sharing portal, and custom CRM ticketing solutions.