SOFTWARE / INFRASTRUCTURE / SECURITY / KENYA
Done
Action completed
Technical Guide Wireless Networking & ISP Solutions Ubiquiti Wireless Configuration Intermediate • 6 min read

Setting up a PowerBeam wireless link

L Author: Lawrence Kamau (Lead Systems Architect & Infrastructure Engineer)
Reviewed by: Peter Mwangi (Senior Network & Field Infrastructure Engineer)
Published: May 1, 2026 • Last Updated: Nov 22, 2026 • Target Hardware: Ubiquiti PowerBeam 5AC Gen2 (PBE-5AC-Gen2, 25 dBi) and PowerBeam 5AC-500 running airOS 8.7+.

Purpose: Deploy a long-range, high-gain directional Point-to-Point link using Ubiquiti PowerBeam 5AC Gen2 dish radios.

Reference Network Topology
Point-to-Point Layer-2 Bridge: Main Office -> Cambium/Ubiquiti PtP Radios -> Remote Branch Switch
NODE 01
Main Office Router & Switch
Gateway VLANs (VLAN 10 Mgmt, VLAN 20 Staff, VLAN 30 Voice)
NODE 02
Master Radio (AP PtP / TDD Master)
Cambium Force 300-25 or Ubiquiti PowerBeam 5AC (WDS Transparent Bridge)
NODE 03
5 GHz Outdoor RF Link (Clear Fresnel)
Aligned azimuth/elevation, shielded Cat6 + surge arrestors
NODE 04
Slave Radio (SM PtP / Station)
Remote building rooftop radio (Management IP on VLAN 10)
NODE 05
Remote Distribution Switch & UniFi APs
Trunk port carrying staff & management VLANs to branch desks

Prerequisites

  • Matched pair of PowerBeam 5AC Gen2 radios with 24V Gigabit PoE injectors.
  • Clear line-of-sight path and sturdy mast mount capable of handling dish wind load.

Step-by-Step Configuration

STEP 01 — Configure Radio A as Access Point PtP

Log in to Radio A, navigate to Wireless, set Wireless Mode to Access Point PtP, set Channel Width to 20 or 40 MHz, choose a clean frequency, and set WPA2-AES key.

STEP 02 — Configure Radio B as Station PtP

On Radio B, set Wireless Mode to Station PtP, lock onto Radio A’s SSID and MAC address, and enter the matching WPA2-AES password.

STEP 03 — Tune Output Power & Distance

Enable Auto Distance and adjust Conducted Tx Power so received signal sits around -50 to -56 dBm without saturating the receiver.

STEP 04 — Align Dishes Using airOS Alignment Tool

Use Tools -> Align Antenna (or the dedicated 2.4 GHz management radio via UISP mobile app on Gen2 models) to peak horizontal and vertical chains.

Expected Results & Verification

Link achieves 8x (256-QAM) capacity on both Tx and Rx chains with consistent throughput and minimal packet retry.

Troubleshooting Matrix

Issue:
Fix:
SECURITY HARDENING

Enable airMAX WPA2-AES encryption and isolate management traffic on a dedicated VLAN.

BACKUP & RECOVERY

Export both AP and Station .cfg files and record exact channel frequency and antenna gain.

L
Lawrence Kamau Delight Engineering Team
Lead Systems Architect & Infrastructure Engineer
Specialization: MikroTik RouterOS 7, FreeRADIUS, Linux CWP Hosting Clusters & Network Architecture

Directs network architecture and server infrastructure at Delight Office Solutions, overseeing the core YouBroadband ISP routing matrix and enterprise deployments.

Tested on Delight Living ISP Network (YouBroadband)
Nairobi NOC • Kabiria Road, Dagoretti South
Related Technical Guides
Was this engineering guide helpful?
Need professional installation, auditing, or troubleshooting? Request Network Consultation →