SOFTWARE / INFRASTRUCTURE / SECURITY / KENYA
Done
Action completed
Lessons Learned Wireless Networking & ISP Solutions Point-to-Point Wireless Links Intermediate • 6 min read

Establishing a wireless bridge between buildings

M Author: Mercy Wanjiku (Full-Stack Software & Systems Engineer)
Reviewed by: Lawrence Kamau (Lead Systems Architect & Infrastructure Engineer)
Published: May 1, 2026 • Last Updated: Nov 22, 2026 • Target Hardware: Ubiquiti NanoStation 5AC / PowerBeam 5AC or Cambium ePMP Force 300-19/25 in transparent Layer-2 bridge mode.

Purpose: Extend an office LAN, VoIP phone system, and VLANs over one link to an adjacent warehouse, annex, or branch office without trenching fibre.

Reference Network Topology
Point-to-Point Layer-2 Bridge: Main Office -> Cambium/Ubiquiti PtP Radios -> Remote Branch Switch
NODE 01
Main Office Router & Switch
Gateway VLANs (VLAN 10 Mgmt, VLAN 20 Staff, VLAN 30 Voice)
NODE 02
Master Radio (AP PtP / TDD Master)
Cambium Force 300-25 or Ubiquiti PowerBeam 5AC (WDS Transparent Bridge)
NODE 03
5 GHz Outdoor RF Link (Clear Fresnel)
Aligned azimuth/elevation, shielded Cat6 + surge arrestors
NODE 04
Slave Radio (SM PtP / Station)
Remote building rooftop radio (Management IP on VLAN 10)
NODE 05
Remote Distribution Switch & UniFi APs
Trunk port carrying staff & management VLANs to branch desks

Prerequisites

  • Unobstructed rooftop-to-rooftop visual line of sight between the two buildings.
  • Managed switches at both buildings if carrying multiple VLANs (Staff, Guest, CCTV, Management).

Step-by-Step Configuration

STEP 01 — Design the Layer-2 Bridge Addressing

Assign two static Management IPs in the same management subnet (e.g., 10.10.10.11 and 10.10.10.12) so both radios remain reachable from the main office.

STEP 02 — Configure Master & Slave Radios in Bridge Mode

Set Building A radio as AP/Master and Building B radio as Station/Slave with WPA2-AES security and matched 20/40 MHz channel width.

STEP 03 — Configure Switch Trunk Ports

Set the switch ports connected to both radios as 802.1Q Trunk ports carrying your required office VLANs.

STEP 04 — Mount, Align & Ground Both Ends

Install Ethernet surge arrestors grounded to each building earth bar and peak signal alignment.

Expected Results & Verification

Building B behaves as a direct switched extension of Building A, with DHCP, domain login, printers, and VoIP working identically across both buildings.

Troubleshooting Matrix

Issue:
Fix:
SECURITY HARDENING

Use WPA2-AES link encryption and disable unused Ethernet ports on dual-port radios.

BACKUP & RECOVERY

Keep saved radio configurations and a labeled VLAN port map in the IT binder.

M
Mercy Wanjiku Delight Engineering Team
Full-Stack Software & Systems Engineer
Specialization: PHP 8.3 / Laravel, AI Workflow Triage, Database Optimization & M-Pesa API Architecture

Architects Delight internal platforms, including the YouBroadband billing engine, landlord revenue-sharing portal, and custom CRM ticketing solutions.

Tested on Delight Living ISP Network (YouBroadband)
Nairobi NOC • Kabiria Road, Dagoretti South
Related Technical Guides
Was this engineering guide helpful?
Need professional installation, auditing, or troubleshooting? Request Network Consultation →